RoboThespian part identification
Jump to navigation
Jump to search
Introduction
RoboThespian is made of hundreds of parts, this page provides labelled diagrams for the most common components. Knowing what part is which will assist you in troubleshooting your RoboThespian.
Shells
The shells are shown in the diagrams below
The shells consist of:
- Face and Mouth shell ( in figure 1)
- Rear Head shell ( in figure 3)
- Front Torso shell ( in figure 1)
- Rear Torso shell ( in figure 2)
- Left and Right Arm shells ( in figure 1)
- Pants shell ( in figure 1)
Base
The connections for communication and powering your robot are located at the base
The base connections consist of:
- Air Line connection (Must be a 6 bar air supply as per the minimum installation requirements ( in figure 4)
- Steel Base Plate (Older models may differ in design) ( in figure 4)
- Wired Network connection ( in figure 4)
- XLR audio connections in/out (Optional, see the TinMan Telepresence page for more information) ( in figure 4)
- RoboThespian Power Supply Unit, a local plug can be sourced for your region ( in figure 4)
Components
There are several components in RoboThespian which are commonly referred to
Torso
Front
The front torso components consist of:
- Elbow Pitch Air Muscle (See Air Muscles for more information) ( in figure 5)
- Microphone Array consisting of 2 forward facing microphones ( in figure 5)
- Speaker (And Digital Amplifier when fitted), the Digital Amplifier is located inside the cavity behind the speaker (See RoboThespian Amplifier Replacement for more information]] ( in figure 5)
- Middle Valve Block, RoboThespians actuators are primarily pneumatically powered, to control the pressurised air there are 3 valve blocks; the Middle Valve Block controls the left and right shoulder pitch and shoulder roll axes (See Valve Boards for more information) ( in figure 5)
- Torso Pitch Motor, the majority of axes are powered pneumatically however the head and torso pitch, roll and yaw axes are actuated with electric motors (See Motors for more information) ( in figure 5)
- Right Valve Board, the Right Valve Board controls the Elbow pitch, Wrist pitch and Shoulder roll axes for the right side of the robot ( in figure 5)
- Shoulder Roll Air Muscle ( in figure 5)
- Left Valve Board, the Left Valve Board controls the Elbow pitch, Wrist pitch and Shoulder roll axes for the left side of the robot ( in figure 5)
- Torso Yaw Motor ( in figure 5)
Rear
The rear torso components consist of:
- Shoulder Yaw Air Muscle ( in figure 6)
- Shoulder Pitch Air Muscle ( in figure 6)
- NUC Breakout Board (With Audio), the NUC breakout is a usb hub for all of the devices to communicate with the NUC; the NUC Breakout Board connects to the Valve Driver Boards on each of the 3 valve blocks and the 2 motion boards. This version of the NUC breakout board has an XLR audio output for cleaner sound, the standard version of the NUC breakout Board does not have this feature. See Breakout Board for more information ( in figure 6)
- Power Breakout Board, see Power Board for more information ( in figure 6)