RoboThespian part identification

From Engineered Arts Wiki
Revision as of 12:50, 17 April 2019 by Chris.c (talk | contribs)
Jump to navigation Jump to search

Introduction

RoboThespian is made of hundreds of parts, this page provides labelled diagrams for the most common components. Knowing what part is which will assist you in troubleshooting your RoboThespian.

Shells

The shells are shown in the diagrams below

  • Figure 1 - RoboThespian body shells: Face and Mouth shell (1), Front Torso shell (2), Left and Right Arm shells (3), Pants shell (4)
  • Figure 2 - RoboTespian body shells: Rear Torso shell (1)
  • Figure 3 - RoboThespian head shells: Rear Head shell (1), Face and Mouth shell (2)
  • The shells consist of:

    • Face and Mouth shell ( in figure 1)
    • Rear Head shell ( in figure 3)
    • Front Torso shell ( in figure 1)
    • Rear Torso shell ( in figure 2)
    • Left and Right Arm shells ( in figure 1)
    • Pants shell ( in figure 1)

    Base

    The connections for communication and powering your robot are located at the base

  • Figure 4 - Base connections: 6 bar Air Line connection (1), Steel Base Plate (Older models may differ) (2), Wired Network connection (3), (Optional) XLR audio connections (4), RoboThespian PSU (Power Supply Unit) (5)
  • The base connections consist of:

    • Air Line connection (Must be a 6 bar air supply as per the minimum installation requirements ( in figure 4)
    • Steel Base Plate (Older models may differ in design) ( in figure 4)
    • Wired Network connection ( in figure 4)
    • XLR audio connections in/out (Optional, see the TinMan Telepresence page for more information) ( in figure 4)
    • RoboThespian Power Supply Unit, a local plug can be sourced for your region ( in figure 4)

    Components

    There are several components in RoboThespian which are commonly referred to

    Torso

  • Figure 5 - RoboThespian components (Front): Face and Mouth shell (1), Front Torso shell (2), Left and Right Arm shells (3), Pants shell (4)